Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version. Compare with Current ·  View Page History

These instructions should assist in configuring your Panasonic DBS Series to work with TIM Enterprise. If you are not familiar with PBX configuration, please contact your system maintainer.

Connection information Description
Connection type Serial Output: Panasonic DBS PBX sends SMDR information via a serial connection. You will need to directly connect a serial cable from the Panasonic DBS PBX to the PC that NetPBX is installed and running on.
Cable configuration Null-modem/Crossover.

Configuring your SMDR

Below you will find instructions on how to configure your Panasonic DBS Series to output SMDR to TIM Enterprise. You will need to do this from the Operator phone:

  1. Press the ON/OFF key.
  2. Press the RECALL key.
  3. Press # twice. You are now in Programming mode.
  4. Navigate to Call logging/Remote programming parameters.
  5. Go to Call logging-parity check and select 1 and then press the # key.
  6. Go to Call logging-even/odd parity and select 1 and then press the # key.
  7. Go to Call logging-baud rate (SMDR) and select 4 and then press the # key.
  8. Go to Call logging-stop bit and select 1 and then press the # key.
  9. Go to Call logging-data length and select 4 and then press the # key.
  10. Got to Call logging-printing selection out/in, select 1 which will give you incoming and outgoing calls
  11. Go to Call logging-printing selection local/long distance calls, select 1 which will print all outgoing calls and then press the # key.
  12. Press the ON/OFF key and you settings will be saved.

Configuring TIM Enterprise

Below you will find steps on how to configure TIM Enterprise to listen for SMDR data from your Panasonic DBS 40:

  1. Browse to TIM Enterprise as normal and login with your credentials.
  2. Click on the Directory tab.
  3. Go the the point in the Directory where you need to add the PBX Object and add a PBX with the name 'Panasonic DBS 40'.
  4. Left-click on it and select Properties.
  5. From the General settings tab select Panasonic DBS Series from the PBX model list.
  6. Panasonic DBS 40
  7. In the Connection tab select No connection required from the Connection method list.
  8. Finally, click on the Save button.
  9. Panasonic DBS 40
Labels: