Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version. Compare with Current ·  View Page History

These instructions help you configure your Panasonic DBS Series phone system to work with TIM Enterprise. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type
  TIM Enterprise establishes a serial connection with this PBX.

Support Files
  Panasonic DBS Series.TDT
Required Tasks
  Configure the SMDR output
  Install NetPBX
  Configure TIM Enterprise

Configuring your SMDR output

Follow the steps below to configure your Panasonic DBS Series to output SMDR data to TIM Enterprise. The configuration needs to be performed from the Operator phone:

  1. Press the ON/OFF key.
  2. Press the RECALL key.
  3. Press ## to enter the Programming mode.
  4. Navigate to Call logging/Remote programming parameters.
  5. Go to Call logging - Parity check and select 1, then press the # key.
  6. Go to Call logging - Even/Odd parity and select 1, then press the # key.
  7. Go to Call logging - Baud rate (SMDR) and select 4, then press the # key.
  8. Go to Call logging - Stop bit and select 1, then press the # key.
  9. Go to Call logging - Data length and select 4, then press the # key.
  10. Go to Call logging - Printing selection out/in and select 1 for incoming and outgoing calls.
  11. Go to Call logging - Printing selection local/long distance calls and select 1 to print all outgoing calls, then press the # key.
  12. Press the ON/OFF key to save the settings.

Installing NetPBX

Install and configure NetPBX

Configuring TIM Enterprise

Once NetPBX is configured and collecting data, log in to TIM Enterprise and perform the following steps:

  1. Click on the Directory tab.
  2. Choose the PBX object you want to configure and click Properties.
  3. A new window will open. In the General tab, select Panasonic DBS Series from the Data format list and tick the Keep a local backup of data box, as shown below: 

  4. In the Connection tab, select No connection required from the Connection method list.
  5. Click on the Save button to apply the settings.

 

Labels: