Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version. Compare with Current ·  View Page History

These instructions help you configure your Siemens Realitis/HiPath DX phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type
  TIM Plus listens for connections from this PBX.

Support Files
  Siemens HiPath DX.TDT
  Siemens HiPath DX.TDS
Required Tasks
  Configure the CIL output
  Configure TIM Plus

Configuring your CIL output

 

CIL access over Ethernet

In addition to CIL access over V.24 ports, in all Realitis DX and iSDX systems with Software Revision 6.0 onwards, the System card or UPI card (Advanced Connectivity Interface (ACI)) allows remote access to the CIL stream over the Ethernet. The CIL TCP server on the System/UPI cards allows a maximum of three concurrent connections from remote clientequipment (e.g. CILE). When the three connections are in use, subsequent connection requests are rejected.

Ethernet port address information is contained in this publication. If the information on how to set-up and activate this feature is required, a request must be made via Product Management at Beeston.

 

Connecting to the CIL server

To gain connection to the CIL server on the System/UPI cards, it is necessary for the remote CILE to open a TCP/IP connection to the IP address of the active side DX. The connection request must contain the logical port number of the particular service required.

The DX System/UPI card TCP/IP address is specified by the variable "IPACT" in the permanent database, the local maintenance engineer would normally program this address.

The listening port is 17257.

Once a connection is established, the DX will begin sending packets to the connected client.

Configuring TIM Plus

Below you will find steps on how to configure TIM Plus to listen for SMDR data from your Siemens Realitis/HiPath DX:

  1. Browse to TIM Plus as normal and login with your credentials.
  2. Click on the Directory tab.
  3. Select the site configured during the setup wizard and click Properties.

  4. Within the Site Properties window, select Siemens HiPath DX from the PBX model drop-down list.
  5. In the Connection method field, select Listen for connections from PBX from the drop-down list.
  6. Leave the Host field blank.
  7. In the Port field, enter in 17257.
  8. Finally, click on the Save button to apply the changes.

 

 

 

 

 

 

Labels: