These instructions help you configure your Panasonic KX-TA/TE phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

<a id="Configure the SMDR output"></a>

Configuring the SMDR output

Follow the steps below to configure your Panasonic KX-TA/TE to output SMDR data to TIM Plus. The configuration needs to be performed from a Panasonic KX-T7130 phone:

  1. Set the System Program Switch on the EMSS Control Unit to the  position.
  2. Press -* followed by the # key, then enter your system password.
  3. Press ## to enter the .

  4. Go to programming code 800 and set each of the fields as shown below. Press  Store and then Next after each entry in order to move to the next field:

    SMDR fieldValue
    NL-CodeCR+LF
    Baud Rate9600
    Word Length8 bits
    ParityNone
    Stop Bit1 bit

  5. Go to programming code 801 and set each of the fields as shown below. Press Store and then Next after each entry in order to move to the next field:

    SMDR fieldValue
    Page LengthLeave as default
    Skip PerfLeave as default

  6. Go to programming code 802 and set each of the fields as shown below. Press Store and then Next after each entry in order to move to the next field:

    SMDR fieldValue
    OutgoingOn
    IncomingOn
  7. Set the System Program Switch back to Store position.
<a id="Install NetPBX"></a>

Installing NetPBX

The Panasonic KX-TA/TE phone system sends SMDR information via a serial connection. To collect the call logging data from the serial port and send it to TIM Plus, you first need to install the NetPBX software. For setup instructions, click on the link below:

Install and configure NetPBX

<a id="Configure TIM Plus"></a>

Configuring TIM Plus

Once NetPBX is configured and collecting data, log in to TIM Plus and perform the steps below:

  1. Click on the Directory tab.
  2. Choose the site you want to configure and click Properties.
  3. In the Site Properties window, select Panasonic KX-TD Series from the PBX model drop-down list.
  4. In the Connection method field, select No connection required from the drop-down list.
  5. Click on the Save button to apply the settings