These instructions help you configure your BT Pathway to work with TIM Enterprise. Contact your system maintainer if you are not familiar with the configuration of your PBX.

<a id="Configure the SMDR output"></a>

Configuring your SMDR output

To receive SMDR data from your BT Pathway you need to have a BT System Phone and be familiar with how to use it to perform system programming. To enable SMDR output, follow the steps below:

1. From the programming position, press the phone setup key P and select System programming.
2. Enter the PIN and select System.
3. Select Call logging and choose Call logging on.
4. Press HANDSFREE/MONITOR to finish.

<a id="Install NetPBX"></a>

Installing NetPBX

The BT Pathway phone system transmits SMDR information via a serial connection. To collect the data from the serial port and send it to TIM Enterprise, you first need to install the NetPBX software. For setup instructions, click on the link below:

Install and configure NetPBX

<a id="Configure TIM Enterprise"></a>

Configuring TIM Enterprise

Once NetPBX is configured and collecting data, log in to TIM Enterprise and perform the following steps:

1. Click on the Directory tab.
2. Locate the PBX object you want to configure in the Directory, right-click on it and select Properties.
3. A new window will open, displaying the general properties of your PBX object. Select  BT Pathway from the Data format list and tick the  box, as shown below:
   
4. Click on the Connection tab and select No connection required from the Connection method list.
5. Click on the Save button to apply the settings.