These instructions help you configure your Samsung DCS phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

<a id="Configure the SMDR output"></a>

Configuring your SMDR output

Below you will find instructions on how to configure your Samsung DCS to output SMDR to TIM Plus. You will need to do this from a LCD handset. Just use the down arrow key to move to each option.

  1. Open Programming and select 725.

  2. Program each option as stated below:

    SMDR fieldValue
    Page HeaderYes
    Lines per page1
    Incoming CallYes
    Outgoing CallYes
    Authorise CodeYes
    SMDR Start TimeYes
    In/Out GroupNo
    DND CallsNo
    Wake-Up CallsNo
    Directory NamesNone
    Caller ID DataYes
    Abandoned CallYes
    No of Dial Mask00
    DID Num/NameYes
  3. Now press the SPKR key.
  4. Select 804.
  5. Dial 0 and use the arrow keys and select SMDR.
  6. Now press the TRSF key.
<a id="Install NetPBX"></a>

Installing NetPBX

The Samsung DCS phone system sends SMDR information via a serial connection. To collect the data from the serial port and send it to TIM Plus, you will first need to install the NetPBX software. For setup instructions, click on the link below:

Install and configure NetPBX

 

<a id="Configure TIM Plus"></a>

Configuring TIM Plus

Once NetPBX is configured and collecting data, log on to TIM Plus as usual and apply the following settings:

  1. Click on the Directory tab.
  2. Select the site configured during the setup wizard and clickProperties.
  3. Within the Site Properties window, select Samsung DCS from the PBX model drop-down list.
  4. In the Connection method field select No connection required from the drop-down list.
  5. Finally, click on the Save button to apply the settings.