Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version. Compare with Current ·  View Page History

These instructions help you configure your Cisco UCME / UC500 to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type
  TIM Plus captures SysLog packets from this PBX.

Support Files
  Cisco UCME - SysLog.TDT
  Cisco UCME - SysLog.TDS
Required Tasks
  Configure UCME to send SysLog events
  Configure Cisco AXL sync
  Configure TIM Plus to capture SysLog packets

Configuring UCME to send SysLog events

Log in to your phone system via Telnet, using the IP address of your Cisco UCME / UC500, as shown below:


Once connected, enter the following commands to enable the Cisco UCME / UC500 to send SysLog events to TIM Plus:

StepIOS commandsDescription
1enableEnter EXEC mode, enter password if requested.
2conf tEnter global configuration mode.
3aaa new-modelEnable aaa accounting mode.
aaa accounting connection h323 start-stop group SysLog
gw-accounting syslog
acct-template callhistory-detail
4logging 192.168.1.1Specifies the IP address to send CDR data. Where '192.168.1.1' is the machine running TIM Plus.
5endExit configuration mode.
6wrSave changes.

Configuring Cisco AXL sync

Below you will find steps on how to configure the Directory Sync from Cisco UCM:

  1. Browse to TIM Plus as normal and login with your credentials.
  2. Click on the Directory tab.
  3. Click on the site configured during the setup wizard and click Properties or create a new site and click Properties.
  4. Within the Site Properties window, select the Sync tab.
  5. Click on the Synchronise with the following device tick box.

  6. In the Host field, enter the IP Address of your UCME / UC500.
  7. In the Username field, enter the username used to login to your UCME / UC500.
  8. Click on the Set button and enter the password used to login to the UCME / UC500, then click OK.
  9. Finally, click on the Save button to apply the settings.

Configuring TIM Plus to capture SysLog packets

Below you will find steps on how to configure TIM Plus to receive data from your Cisco UCM:

  1. Browse to TIM Plus as normal and login with your credentials.
  2. Click on the Directory tab.
  3. Select the site configured during the setup wizard and click Properties.

  4. Within the Site Properties window, select Cisco UCME - SysLog from the PBX model drop-down list.
  5. In the Connection method field, select SysLog connection from the drop-down list.
  6. In the Client IP field, enter in the IP Address of the Cisco UCME / UC500.
  7. Finally, click on the Save button to apply the settings.

 

Labels: