Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version. Compare with Current ·  View Page History

These instructions help you configure your Cisco UCME / UC500 to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Connection Type
  TIM Plus captures SysLog packets from this PBX.

Support Files
  Cisco UCME - SysLog.TDT
  Cisco UCME - SysLog.TDS
Required Tasks
  Configure UCME to send SysLog events
  Configure Cisco AXL sync
  Configure TIM Plus to capture RADIUS packets

Configure UCME to send SysLog events

Login to your Cisco UCME / UC500 via telnet, as shown below:


Now just enter the following SysLog commands:

StepIOS commandsDescription
1enableEnter EXEC mode, enter password if requested.
2conf tEnter global configuration mode.
3aaa new-modelEnable aaa accounting mode.
aaa accounting connection h323 start-stop group SysLog
gw-accounting syslog
acct-template callhistory-detail
4logging 192.168.1.1Specifies the IP address to send CDR data. Where '192.168.1.1' is the machine running TIM Plus.
5endExit configuration mode.
6wrSave changes.

 

 

 

Labels: