Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

These instructions help you configure your Samsung DCS phone system to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

Pbxsummary
Supportfiles1Samsung DCS.TDT
Supportfiles2Samsung DCS.TDS
ConnectionSerial connection
RequiredTask1Configure the SMDR output
RequiredTask2Install NetPBX
RequiredTask3Configure TIM Plus

HTML
<a id="Configure the SMDR output"></a>

Configuring your SMDR output

Follow the instructions below to configure your Samsung DCS to output SMDR data  to TIM Plus. The configuration needs to be performed from a LCD handset.

  1. Open
    Referencemacro
    LabelProgramming
    and select 725.
  2. Program each option as presented below:

    SMDR fieldValue
    Page HeaderYes
    Lines per page1
    Incoming CallYes
    Outgoing CallYes
    Authorise CodeYes
    SMDR Start TimeYes
    In/Out GroupNo
    DND CallsNo
    Wake-Up CallsNo
    Directory NamesNone
    Caller ID DataYes
    Abandoned CallYes
    No of Dial Mask00
    DID Num/NameYes
  3. Next, press the SPKR key and select 804.
  4. Dial 0 and use the arrow keys to select SMDR.
  5. Press the TRSF key to complete the configuration.
HTML
<a id="Install NetPBX"></a>

Installing NetPBX

The Samsung DCS phone system sends SMDR data via a serial connection. To collect the data from the serial port and send it to TIM Plus, you first need to install the NetPBX software. For setup instructions, click on the link below:

Install and configure NetPBX

HTML
<a id="Configure TIM Plus"></a>

Configuring TIM Plus

Once NetPBX is configured and collecting data, log in to TIM Plus and perform the steps below:

  1. Click on the Directory tab.
  2. Choose the site you want to configure and clickProperties.
    Screenshotmacro
    Borderfalse
    URL/download/attachments/4817089/samsung_dcs_1.png
  3. In the Site Properties window, select Samsung DCS from the PBX model drop-down list.
  4. In the Connection method field, select No connection required from the drop-down list.
  5. Click on the Save button to apply the settings.