Panasonic KX-TA/TE

...

1. Set the System Program Switch to on the EMSS From the back of the phone, set this to ProgramEMSS Control Unit to the

   Buttonmacro
   Label Programming

    position.
2. Press -* followed by the # key, then enter your system password.
3. Press ## to enter the

   Referencemacro
   Label Programming mode

   .

4. Go to programming code 800 and set each of the settings fields as shown below. Press  Store and then Next after each entry , in order to move to the next settingfield:

   SMDR field	Value
   NL-Code	CR+LF
   Baud Rate	9600
   Word Length	8 bits
   Parity	None
   Stop Bit	1 bit

5. Go to programming code 801 and set each of the settings fields as shown below. Press Store and then Next after each entry , in order to move to the next settingfield:

   SMDR field	Value
   Page Length	Leave as default
   Skip Perf	Leave as default

6. Go to programming code 802 and set each of the settings fields as shown below. Press Store and then Next after each entry , in order to move to the next settingfield:

   SMDR field	Value
   Outgoing	On
   Incoming	On

7. From Set the back of the phone, set this back to Store System Program Switch back to Store position.

<a id="Install NetPBX"></a>

...